TOTALINE 1 FOR ALL P474-0100 OWNER'S MANUAL Pdf Download (2024)

FAQs

How do I Program my Totaline thermostat? ›

During Setup & Programming: Pressing the UP or DOWN buttons will modify the flashing selection. To adjust the time by hours press and hold the FAN button while pressing the UP or DOWN buttons. The HEAT setting indicates the temperature the room has to reach before the furnace will turn on to heat the room.

Push the "Mode" and "Fan" keys at the same time. Release both keys after seven seconds.

Pressing the UP or DOWN buttons in Heat or Cool mode will adjust only the heat or cool set temperature. Fan On indicates constant fan operation. You may turn the fan on even if the thermostat is in the Off mode. Pressing the FAN button toggles this feature on or off.

Start by selecting a day of the week and inputting the time when you want the first period of the day to start and the temperature, or set point, you want during that period. Then set the next period and so on until that day is finished. (Some models allow you to copy the schedule from one day to the next.)

Find the breaker to your HVAC system, flipping it 'off'. Make sure the breaker is flipped all the way 'off,' then wait for 30-seconds. Turn the breaker back 'on. ' Return to the thermostat control panel and flip the thermostat back into the 'on' position.

Flip the circuit breaker that powers your thermostat to the 'off' position. Wait 30 seconds. Flip the circuit breaker back on. Switch the thermostat mode from 'off' to 'auto', 'fan', 'cool', or 'heat'.

Try checking the circuit breaker box or replacing the batteries. Bad wiring: The thermostat may be unresponsive if the wiring has gone bad. Remove the cover and check inside for loose, detached, or corroded wires. If you spot any problems, contact an HVAC technician for assistance.

When you set the thermostat above or below the current room temperature, you should hear a click, and the AC or furnace should kick on almost immediately. If you make changes at the thermostat and nothing happens, that's the first sign you have a bad thermostat.

How do you reset a thermostat that is not cooling? ›

Install the batteries backwards. Wait 5 seconds, then reinstall batteries properly to reset. If your thermostat has a recessed reset button, press it in with a paper clip, holding it in for 5 seconds before release. If neither of the above methods work, turn your thermostat to the 'off' position.

HEAT - Indicates the heating mode. COOL - Indicates the air conditioning mode. AUTO - Indicates the system will automatically changeover between heat and cool modes as the temperature varies. OFF - Indicates heating and cooling is turned off.

Keeping your fan on AUTO is the most energy-efficient option. The fan only runs when the system is on and not continuously. There is better dehumidification in your home during the summer months. When your fan is set to AUTO, moisture from cold cooling coils can drip and be drained outside.

Your furnace fan helps heat your home by pushing warm air through the vents. Incorrect settings on your thermostat or fan limit switch can cause the fan to run continuously. Faulty wiring or a broken fan limit switch can also cause your fan to keep running. You can diagnose and fix some furnace fan issues on your own.

No power: If the thermostat isn't working at all, there could be a power issue. Try checking the circuit breaker box or replacing the batteries. Bad wiring: The thermostat may be unresponsive if the wiring has gone bad. Remove the cover and check inside for loose, detached, or corroded wires.